The problem is I can't ping remote subnets from either router. the network that you want connect to through the VPN) is used (e.g. Hi,I have the following setup and I have the HUB and SPOKE connected through a IKEV2 tunnel using FlexVPN. Remote Side Set the 'Endpoint Mode' to Network and enter in the NebulaCC address subnet you wish to access. Local Side Set the 'Endpoint Mode' to Auto.
Primarily with IPSecuritas and Mac OS X, but a handful of times with the Zyxel VPN. Since Android (at least up to Nougat) does not support IKEv2, we will use a certificate-based IKEv1 setup (IPsec Xauth RSA in Android speak). Select VPN in the dropdown menu Interface and IKEv2 as VPN Type. add conn xauth-hybrid leftsendcertalways rightauthxauth autoadd conn ipsecuritas IPSecuritas apparently needs a specific IP or the CHILDSA cannot be found. Start by creating a new user on the Firebox Edge and then configure MUVPN support for this user. After switching to OpenWRT from DD-WRT which doesn't support IPsec, this is post describes the settings I use. Since Android (at least up to Nougat) does not support IKEv2, we will use a certificate-based IKEv1 setup (IPsec Xauth RSA in Android speak). Please note however that we can't guarantee that this setup will work in all cases.
Older Firmwareĭevices running an older firmware may often work using the following setup. For details please see our configuration guide. WatchGuard Firebox X Edge e-Series devices with Fireware XTM (Fireware 11) are fully supported in current versions of VPN Tracker.